在安装化工离心泵的时候，需要分六部完成具体的操作，操作得当可以让护工离心泵在使用时产生非常好的工作状态，如果安装不好可能减少泵的寿命，或者无法正常使用。
安装前，收到厂家发送的化工离心泵后要先检查，有没有损坏，或者泵内有无进入污垢等，如果有要及时清理，拆卸，如果完好无损无污，则可以直接安装。在安装化工离心泵时先做好泵的基础平面，然后凝固后将泵安装到平面上，看是否水平，然后灌浆孔浇灌水泥固定。在固定好后再次检查水平，是否有倾斜。检测联轴器的外圆和两联轴器端面间隙误差不能超过0.1毫米。检查吸入管路和压出管理的支架是否搭建好。离心泵的安装位置是否吸入管道上安装控制阀门和过滤装置，防止污物进入泵内(图\文www.wxjpby.com/)。
中译英：
In the installation of chemical centrifugal pump when, need six completion of specific operations, operating properly can let workers centrifugal pump in use have a very good working state, if the installation is not good may reduce the pump life, or cannot be used normally.
Before installation, received the factory sends the chemical centrifugal pump after the first examination, there is no damage, or in the pump without entering the dirt, if there is time to clean up, remove, if intact and no pollution, can be installed directly. In the installation of chemical centrifugal pump well pump when the first foundation plane, then after the solidification of the pump is mounted to the plane, see whether level, then watering hole grouting cement fixation. The fixed again after inspection level, whether the tilt. Measurement of coupling and the outer circle of two coupling end clearance error can not be more than 0.1mm. Check the suction pipe and the pressure of management support is built. Centrifugal pump installation position whether inhaled installed on the pipeline control valve and filter, preventing dirt from entering the pump.